Electric gate repairs in Southend, Leigh-on-Sea, Westcliff and Shoeburyness: motors, control boards, photocells and remotes on all brands, from a family-run Essex team.
Gate faults are usually a chain: a worn hinge makes the motor work harder, the board trips, and the gate stops. We trace the fault back to its cause so the repair lasts.
We repair swing gates, sliding gates and barriers with Roger Technology, FAAC and BFT motors and control boards, along with many other brands, including gates installed by other companies.
Our family-run team is based in Chafford Hundred, about 23 miles from Southend by road along the A13.
Call 01375 886299
This is general advice for any gate near the coast. Salt in the air settles on hinges, fixings, ground tracks and motor housings and speeds up corrosion. It can also get into poorly sealed junction boxes and cause intermittent faults that come and go with the weather.
Regular cleaning, lubrication and checks of seals and connections make a real difference. If a gate is already corroded, our engineers are coded welders and can repair the structure on site, or advise when replacement makes more sense.
See gate servicing and maintenance for what a service covers.
The faults we are called out for most, on swing gates, sliding gates and barriers.
Often a control board, power or motor fault, or a safety device telling the board the way is blocked. We test each part in turn rather than guessing.
Usually photocells that are dirty, misaligned or failing, a safety edge that has been knocked, or a motor struggling against stiff hinges or a dirty track.
Most control boards signal an error with beeps or a flashing light. We read the fault on site and repair the cause, not just the symptom.
Try fresh remote batteries first. If that doesn't fix it, we re-code remotes and receivers, or fit Remootio so you can open the gate from your phone.
Call 01375 886299 or send the details. Photos or a short video of the gate and control box help us bring the right parts.
We test the supply, control board, motors and every safety device, and explain what we find before any work starts.
We repair or replace the faulty part, then test photocells, safety edges and force settings to BS EN 12453.
If the fault came from wear or a poor original install, we tell you, and suggest servicing so it doesn't come back.
Check the power supply, look for anything blocking the photocells, and note any beeps or lights on the control board. That information often points straight to the fault.
If the remotes are the problem, Remootio lets you open the gate from your phone. Photocells? We fit FT100 universal photocells. Read automatic gate repairs explained.
Nearby: electric gate repairs in Basildon and electric gate installers in Southend.
Common questions about gate repairs in Southend, Leigh-on-Sea and Westcliff.
Salt air can speed up corrosion on hinges, fixings, tracks and motor housings, and can affect electrical connections. Near the coast, a yearly service matters more: we clean, lubricate and check for corrosion before it causes a failure.
Yes. We work on Roger Technology, FAAC and BFT and many other brands, including gates installed by other companies.
Replace the remote battery first, then check whether the gate responds to a wall button or keypad. If it does, the remote or receiver is the likely fault. If nothing works, it may be the control board or motor.
Yes. We can fit Remootio while we are on site, so you can open the gate from your phone.
Southend-on-Sea, Leigh-on-Sea, Westcliff, Thorpe Bay, Shoeburyness, Eastwood and Prittlewell. We are about 23 miles away in Chafford Hundred.
Back to electric gate repairs in Essex. Planning a new gate? See electric gates in Southend-on-Sea or Rayleigh. We also cover gate repairs in Basildon.
Call us or send the details and we will arrange a visit.